Thanks sir, I think next time I'll use white glue to secure till primer. The Testors stuff is a bit to hot. The punch does work as advertised though, I highly recommend it.Ryan
To replace the rivets I got to use a tool I picked up at the US Nationals...the UMM Beading and Riveting punch. The punch produces round head rivets pressed out of thin metal. The goal was to replace the look of the SH kit rivets. I tested the sub miniature rivets on a section of sprue.1/32 Morane Type N by The 3rd Placer, on Flickr 1/32 Morane Type N by The 3rd Placer, on FlickrA dot of Testors liquid glue was placed where I wanted the tiny fastener to be located. The rivet was then punched and stuck on.Did I mention they were small?1/32 Morane Type N by The 3rd Placer, on FlickrRyan