Wow, what a great feedback! Thank you all!
So I should continue immediately with:
Upper wingThe upper side is taped ...
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhM1JNZFhXUTFZVmM)
... and painted:
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLheHA1LV80SnBkMlU)
After painting the ribs with wood brown the bottom side is also masked:
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhNkg2aUJHajFQOGM)
With help of a floating mask ...
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhNlNxWTBVbmlmNlk)
... I pianted the shadows of the crosses and lighten all up:
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhYzN0eXNISzVESFk)
The final result after painting the bottom side
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhX2VhZWoyNWN4aVU)
... and the upper side. My typical fault: a bit to much paint!
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhaVEwcy0tTDE4NjQ)
The tail skid is painted in wooden acrylic paints:
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhVERRTURYNERvVWs)
I cutted the control horns and soldered a 0,5mm pipe to them ...
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhQW1NS0NKeHZzZnM)
... to hold later a Gaspatch tunrbuckle of typ "one end":
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhSlFnWDhwbGw4anM)
The control "wires" are prepared with brass tubes and turnbuckles, which is easier outside of the model.
![](https://drive.google.com/uc?export=view&id=0B1jvv6k_doLhTE1MVVdCWHdVcWM)
Little progress for a lot of work!
Cheers,
Bughunter