Thank's guy's
Today, i did some work regarding the seam's where the two fuselage half's came together.
First, some taping, so i can get a nice thin line of putty.
For this i use Tamiya putty mixed with Revell Contacta Liquid, this micture give me some drying time room, and i can pin-point my putty to certain places.
After 15 minutes i remove all tape,
The putty on the fuselage needs to dry some time, so meanwhile i take a closer look at the bottom wing.
The Constantino pump has to be removed from the wing, so with the help of an improved electrical toothbrush this was done within five minutes.
After removal
Two panellines needed some attention after sanding, i think this will be the only two panellines that i will have to rescribe on the entire plane.:hmmm:
Ok, time to sand the putty on the fuselage, again, with the help of my electrical toothbrush.
The vertical fin on the bottom of the fuselage is allready glued.
The inner part of the bottom wing can be seen into the cockpit, so, some painting and a wash gave this a rather dirty appearance.
That's all for now.
Greetz
Danny
