I had a productive day yesterday... until My Compressor threw a bearing , blew it's gasket, or whatever happened.
I did manage to apply 4 out of the 5 colors to the upper surfaces before that happened. Other than some touch up and tweaking, and of course the black, I am satisfied with the results. ( The most obvious touch up needed is on the horizontal tail) I have also "Tried" to keep better track of My Mixes, with mixed results
RAGIII
Now for the mix info:
The beige Mix: It started at about 3 to 1 of the Desert Tan and Bone white. From there I might have changed it a bit but should be in the ballpark.
Next the Light Green: Again the starting point was about 3 to 1 of The Pale Green to the Green Grey. I think I added a drop or two of white.
Next up was the Dark Green: About 2 to 1 US Dark Green to Russian Green. A few drops of white.
Finally the Chestnut Brown: I started with about a 3 to one ratio of brown to red. It wasn't enough red so I kind of lost track but think I ended up with more red than brown. I also think I added a couple of drops of white
What I learned is that I really can't keep very good track of MY Mixtures. I start with good intentions but then I keep adding stuff untill I like it. So if nothing else one can see the colors I started with and go from there on your own
PS: I forgot to mention that for the fabric areas I added a squirt of Metal Medium