Hi everybody!
I went on with the front side.
the morane AI front side is organized in three parts just liike in this Morane type P:

Below, a fixed part in 1, upper fixed part in 2 and a mobil lateral part in 4 with hinges in each side (3)
first the low part done with palstic card, surfacer and aluminium tape

then I usde plastic card to represent the lateral parts. i wanted to represent that metal parts take the fuselage form

then the upper part , only with surfacer


The Navarre Morane is a MoS 30 type , unarmed trainig plane, so i don't know if I had to represent the hinges in 2. in the doubt I did....
then archer rivets and hinges.
I didn't like at all the archer hinges effect so I did them again :

find it better:

final result:

hinges are a little bit oversize but below the wing, it will be OK
akyway better that how it was at the begining...

next step , the engine and the cowling
Xan