Hi Jeff per the post above --
I had to refactor the accessory sprues, due to changes in Shapeway's pricing structure (the original accessory sprues contained many individual parts; the new pricing model has a per-part cost which made these astronomical (more astronomical?). Good news of course is that we finally have orientation control, meaning us designers, not some rando tech who doesn't know a Fokker from a fork, get to decide where the icky artifacts end up.
Unfortunately, the first iteration of one of my sprued accessory trees failed the minimum wire diameter test, so I cancelled the test run. And then I pretty much ran out of spare money and time, and so it sits in limbo... The changes required a minimal and don't affect the detail at all (the basic geometry has all been printed many many times...
Anyway, I don't want to put these on sale again until I've completed a test print, and lately funds are tight, and the interest in this has been modest to say the least. soooooooo...
