Hi my friends. About time for a bit of an update.
The next step is to start thinking about the struts and rigging. I drilled out all
the wire attachment points on the struts with a 0.3mm bit, then attached the
front cabanes. The Vickers is the kit part painted with Gunze Black Iron and
buffed to show some wear, just set roughly in place unglued in the picture.

Starting to attach the bracing wires...

On the Pup there are a few places where the, rigging wires attach to the wings
without eyelets. For those, instead of trying to attach the monofilament by itself,
which I never have much luck at, I CA'd the line to a 0.3mm brass tube and cut the
tube to around 1mm. It makes it easy to install into the drilled holes in the wing
securely and without mishap.

Next I attached the Vickers and began connecting the cross bracing which will be
tightened after the top wing is installed.

Sorry for the last picture. Not the best.


That's about it for now. The saga will continue before long. Thanks for looking
everyone. Any advice/suggestions gratefully received.

Cheers,
Ernie
