Thank you, everyone.
excellent work on the wheels! I tried PE spokes a couple of times and met with disaster. You are a Master!
RAGIII
Rick, I am sure you would do well with these, the key to the success is that axle hub which centres it all and facilitates the assembly. Great design from Rowan!
And here a few more steps
The fuselage joints are finally cured. I have also added the PE side steps. Also some fitting of the PE generator support revealed that the rear hole is mislocated - I had to fill it (the white spot).
I did not quite like the way to lead the control lines for the ailerons as designed by WNW. So I decided to remove the plastic imitation of turnbuckles and the cable from the control horns and replaced them with Gaspatch bits. Thus I will have a chance to lead the cables from the openinigs in the wings through the holes drilled in the horn tips to the eyelets in the turnbuckles.
