Hi all,
Cross bracing wires were fitted between the tops of the rear fuselage cabane struts and the inside of the fuselage.
These wires were attached to a small rectangular frame, located on the top centre of the cockpit front decking panel.
Each of the four separate bracing wires were attached the corners of this frame.
The model has the rectangular attachment frame moulded solid, which does not represent the actual frame.
The ‘Brengun’ photo-etch set has two frames, either of which (or both) can be used, but attaching them to the decking panel and rigging is not explained.
I removed the pre-moulded lump and drilled two holes of 0.5 mm diameter at approximately 60 degrees, down and through the front decking panel.
Two lines of 0.08 mm diameter mono-filament were passed through 0.4 mm diameter tube, then through the photo-etch frame.
The lines were looped back through the tubes the secured in position with thin CA adhesive.
The following shot shows it test fitted. The frame will be finally fitted later in the build during the rigging phase,
Mike