TailTo be able to prime and paint fuselage and wings I need to sort out the tail.
Those are the tail parts. Not bad, only the mounting is not easy because of the special position of the tailplane. And I cannot mount it now, because the lower surface of the tailplane needs linen, the other surfaces PC10.
So I used a fine resin saw and cut all in single parts. The control surfaces are now pinned (which was not easy because all parts are thin). All pictures shown the tail control surfaces down, so I can do that now.
I replaced the resin wedge with a new one and pinned all.
Now all of this crazy tail fits and can be easily mounted after painting.
I like the look!
As I have just cut off all the control surfaces at the tail (which I actually always do, as it makes a model much more realistic and lively), I then cut off the ailerons. I didn't dare at first because they are so delicate. Now they are pinned with 0.3mm brass.
Fortunately only the two upper wings have ailerons.
Only a little progress, but it was a lot of work with fine saw and drills.
Cheers,
Frank