Thank you, my friends!
Andreas, in the first post you see the painting guide of this french red one. May be this is wrong, I don't know.
Tail assemblyThe connection between both elevators is very thin, fragile and should be glued to the end of the fuselage?! There are also 4 small horns.
For transportation to exhibitions I want to have it more robust, so cut and drilled small hole for brass rod.
Attention, a small kit error: there are 4 outlets on upper and lower side, but only on the upper side 4 are needed, because the rudder is only controlled from upper side.
I created a new construction for holding the elevator. Same was done already for my Morane-Saulnier type-L where I had good pictures:
I assume a comparable construction here because the manufacturer is identical.
Mounted on the fuselage, the brass rod will go through the tube.
With elevator:
The plastic shows some ribs representation, which I shadowed a bit.
The rudder was cut and new hinges are created.
After decal on the rudder I added all linkages. This is easier with elevator not yet mounted.
The elevators are painted using the kit provided masks.
In next update I will show the rotary engine.
Cheers,
Frank
