Hallo mates!
Some news from the Breguet XIV factory...
The Misterkit Paints have arrived,
and the Gaspatch Vickers and Lewis also.
So I invented the two supports for the external Vickers:
The fuselage halves have no matching pin to facilitate the join so I placed a couple of plasticard tunes and copper pins.
I provisionally sticked the sides of the cockpit framework to locate the position, then I dry joined the 4 sides:
I inserted the white plasticard rod where the control column will go
And prepared the resin seat:
Also the wings have no matching pins to get glued to the fuselage, so I drilled two holes per fuselage half and inserted as a test 2 chunks of copper wire:
Then each wing has been drilled accordingly:
I did not see any photo of the interiors showing some walls inside the fuselage but I imagined a firewall behind the engine compartment and one small bulkhead behind the gunner just because the cockpit holes are large and looking inside would have shown too much the empty spaces ahead and behind.
In the starboard half I glued two small pieces of plastic to facilitate the glue grip:
That's all for today!
Thanks for watching
Antonio