Hi Frank ,
Yes I have this photo already saved and you are right . It is the clearest showing just how thin the wings are . No issue at all with the resin wings . No air bubbles or short shot and the lower wing fits perfect ! I was expecting to have to do a fair bit of sanding , but this is not the case .
Made a start on the floor by thinning the towards the rear on the underside so this sits lower . Areas on the side and middle of the heel plates was removed and new details added and a brass pin/nut for the rudder bar . Front part for the control column support is under way which is still a work in progress . So far this is what I was able to get done today .
Terri