Well I didn't get as much done as I was hoping too . But I have covered new ground with the progress . I spend some time on the cowl . Had a fair bit of clean up do to mismatch molds leaving only part of the cowl lip . So what was left got sanded away , now it's all over my floor . This was replace with 0.4mm plastic rod . PE parts added to the tail skid . Landing gear felt left out so it got some details as well , struts are cleaned up and ready for brass pins . The mounting hole in the wings I filled with 1mm rod for a better platform to mount the struts . Wheels are also set to go . Just a few more bits and bobs and it's off to primer

Tail feathers are cut free . The hinges were a mis-match on the other side , so new ones will be made .