Thanks guys for stopping by and leaving your much appreciated comments.
When fitting the struts I cut off the resin pins and replace them with 0.5mm copper wire, I drill a 0.6mm hole into the end of the struts then CA the copper wire, the wire can then be cut and bent to shape, it is very easy to work with but makes a strong connection.
I finished the two propeller drive gearbox units and fitted them to the bottom wing, the main drive from the engine to the two gearbox units are also fitted. I was very surprised at how easy it was to fit these units, finding the correct length strut is crucial but having scale plans to compare each strut makes life very easy. Once the correct struts were found both units virtually fell together
Des.
