George,
I don't have absolute numbers for you but I figure I used approximately 110 of von Buckles Turnbuckles and minimum 140 tubes, the majority 1.5 mm's. the remainder were 1.0mm's. I'd say you need to have minimum 125 buckles, 125 tubes of the 1.5 mm size, and 30 1mm size to have enough and a comfortable reserve to replace the bits you are going to "tweezerpult" off into the ether as you labour away. It's not a difficult task, just a long one. I cannot recommend the tutorial on von Buckles Website highly enough, it really keeps things on the rails. There are a couple of "grey zones", don't hesitate to ask as the time I spent poring over photos and articles is for sharing if of any help. The cabanes are an enigma to me, I chose to rig them fully however it seems every clear illustration of them shows a different configuration.
I'd bet that everyone here who has rigged one of these monsters has a different "count" on components, it's not any more definite then the colour of PC10! Last, I used mono for the conventional structures and EZ Line for the Lattice frames. Any mono added to the frames caused warping and was quickly replaced. I've since tried Modelkastens semi stretchable thread elsewhere and I figure it would provide too much tension as well.
Good luck, I'll be following your journey closely!
Cheers,
Lance
