Hello everyone
... continue! As I wrote in one of the above my posts, the operation of the diorama will develop in front of Hangar 2 Boistrancourt. Relying on information from the book by GK Merrill series of Windsock Datafile Special "Jagdstaffel 5" found that in this hangar were housed three Albatroses DV - Albatros DV, serial unknown, pilot: unknown, Albatros DV 2065/17, pilot: Obit. Richard Flashar, Albatros DV, serial unknown, pilot: Vzfw. Fritz Rumey:
This led to the decision to eliminate one of the planes in the diorama. I decided to send him to the service of the Jasta 37 for the needs of Ernst Udet:
Briefly what work finished on models: After final assembly, diligently washed the plastic with alcohol. Because I do not use a primer that has enormous implications for the adhesion of the paint. The next step is the application of paint. I work with brush and for this project I used paints Vallejo, of which I have very good impressions. Very well spill, cover and leave no traces of brush. As minus noticed that even sealed with varnish of Vallejo, after taking the decals, the water that has remained in them rises the paint and makes it as noodles. If any of you faced similar problem and found solutions to it I'll be giving thanks if you share. Followed by application of the decals. I used the default decals of Eduard, such as missing me for making the plane Rumey and red crest horse I print ot gelatin paper, which was very hard work. Finally, all sealed with two hands lacquer.
Here are some pictures:
Next step weathering.
You'll be glad of any advice, recommendations and constructive criticism of the project.
Best Regards
Hristo
