cutting thin copper wire without messing up the ends?

[Chuckt5]

I want to cut some soft copper wire that is .3mm in diameter (pretty thin). Normally I would just use a wire cutter to cut it, but the problem with the wire cutter is it leaves the end all crimped and smooshed!

Does anyone out there have a good method for cutting wire this thin that leaves the end relatively square and not sqaushed?

Thanks in advance, chuckT.

[uncletony]

Cut it with a #11 knife using a rolling action like you would cut a tube.

[Chuckt5]

Thank you 

I was wondering about that.

[ALBATROS1234]

yeah what bo said.

[Chuckt5]

Thanks.  I also discovered my orange handled Xuron cutters seem to make a nice square cut too!