Good to see that bird is able to fly again.
Perhaps I won't try again at once...
Thanks all friends for your nice comments!
I could at last stat the last step, make a wooden prop.
I usually do french palnes wich propelers were painted with tonkylaque, this german plane give me the ocasion to try it. All the wooden prop I saw were done at 1/32 and I wanted to see if it was possible at 1/48...
so let's go:
The propeler is a Reschke
après importation de cet image sur le logiciel de dessin vectoriel silhouette studio ou un autre peu importe, on obtient cela:I importes theis picture and did the drawing i a vectorial drawing software (silhouette studio in this case)
Then i put at the right scale
I buy marquetry wood (0.5mm wood sheet)
Then i used the plotter (cameo silhouette)
have to be carefull taking the prop parts off
all is ready
glue with white glue
then started:
first try was not so good, but i saw it works...
second try was better:
here is the prop logo
Borsos indicate me Lf models did it at 1/48; thank you Andreas!
Then i pass a raw sienna oil paint layer varnish and here is the result
Not that bad!
Xan