Thank you for the kind words.
Guy, I am no master, there are more subtle ways to do the ignition wiring than mine. But if you like my method - it uses a thin (0.25mm) soldering wire - easy to bend, cut and glue with CA. Cut the measured lengths with some excess, glue one end into a hole drilled in magneto, paint to the desired colour (I hear there were multitudes of possibilities), bend glue to the spark plug and when glue is set - cut the excess with sharp razor blade. One could add some additional elements like holding rings or other fittings. Des had shown it finely in his parallel Dolphin build. I decided to skip this part, as in the matter of fact even without the top cowling such subtleties will not be visible in this model.
