Thank you !!!
Hi !
I remade the cylinders entirely with evergreen plastic, I could not stick the small parts cleanly with superglue on the resin parts, and their foot was too short. It was long and painful ...
The springs are made of copper wire (gold), found in "fly fishing" shop. It is thinner than the wire.
I wanted to make them conical. Well... believe me it is difficult to find the point suitable for winding the wire over.
Finally I 'm using an old needle (fine) my airbrush (Pasch).
Everything is covered with "surfacer".
Welds are plastic yarn stuck to the liquid adhesive and crushed with the back of the tweezers
The shape could have been crowned at the top ... but I do not want to start over.
Tomorrow I make the mold.
Regards