All,
I'm starting to worry I've become a bit of bore on this build (I am getting this one together quickly) so apologies!
However, I did some more work over the last couple of evenings. I have now painted, applied decals, fitted and rigged the top wing. Fitting the upper wing proved to be a bit of a challenge - tricky getting the cabane struts to fit (when installed on fuselage the part that attaches to underside of wing were angled and not straight - wing attachment slots are straight) so involved twisting the cabane struts at the top to correctly meet the wing attachment point on the underside. Got there in the end though - all three wings have aligned beautifully when view from top and bottom.
However, I have had to settle for a less than perfect fit to the cabane struts, especially on the port side. Try as I might I could not get then to match the angle of the lower strut already in place. In the end, settled (after lots of shunting around) for the best fit/angle I could obtain. I hope it does not look too bad?
So I am now on the 'downhill slide' with this build now - only the landing gear, under wing skids and prop to go!
One thing worth mentioning is the quality of the kit decals. They are superb - very easy to work with and react especially well to decal setting/softening solutions. In fact, they put to shame some of those supplied in other, more expensive kits. I really liked working with them.
More to follow in due course.
Regards
Dave