Speaking of props..in order to perform wood grain I have implemented AIZU tape and enhanced the outcome by oil paints. As the last the gloss varnish is going to be spayed.



I have encountered the enormous difficulties with polish checker on upper wings…the decals were so thin an visible that I had to risk and prepare the mask on swirls..

Those decals have been well protected previously but I am always afraid on doing anything on decals)
I have decided to limit the contact layer to minimum and used AIZU once again.
The checkers were surrounded by AIZU and rest of risky areas covered by some paper sheets. The outcome is satisfactory


Same will be prepared for second wing part
As I did not have any additional decals with no.2, a layer of white dry pigment+akryl pactra+water has been done several times.

regards
k