Hello.
Here's the UFAG, a nice aircraft. Good plans and the bulkhead templates were very useful. I even made a planked floor with microstrip over card. Its a lovely model, these Sierra Scale kits are good. Plastic parts are a bit ropey, although the propeller and white-metal Schwarzlose mg are very nice. Might leave the upper cowlings off to show the mg and engine, as apparently not much is known about the interior of the crew compartment. Has an unusual gun ring too, which will need careful filing out.
Managed to split the plastic round the gun ring whilst sanding away excess plastic with sandpaper wrapped round a marker barrel
The plastic is drawn very thin round this part, so be careful. A dab of liquid cement sorted it, I'll reinforce it with plastic strip later on.
Not a fault of the kit though.
The last pic shows the amount of overlap on the lower wing halves, which will give a nice sharp trailing edge (I also couldn't resist seeing how it looked ).
Interior so far from stretched sprue, bulkheads from spare plastic in the vacform sheet. Plastic rod is too thick, (same as the vac Aviatik) but its just a guide for the one which will be in brass tube, it also helps to centre the rudder bar and other details which I'll be doing soon.
I've also assembled the mainwings, and, as usual, cut off the ailerons to add later at a jaunty angle, lol.
There you go
