Hi all,
Some progress on the Albatros D.I.
The smoothed and grey primed surfaces were clear gloss coated with 'Alclad' Aqua Gloss 600.
The undersides of the wings and tail unit had the ‘Aviattic’ German blue linen (ATT32077) white backed decal applied.
The upper surfaces of the wings and tail unit had the ‘Aviattic’ clear Linen Weave effect (ATT32236) decal applied.
All surfaces were then airbrushed with 'Alclad' Light Sheen (ALC311) lacquer.
The 'Roden' kit supplied decals were as expected very thin and fragile and were easily broken when applied.
Also this particular aircraft had marking not available as decals.
Therefore I inkjet printed all of the decals required onto white decal paper then sealed them with two coats of acrylic sealer.
I decided to try out the 'Quinta Studios’ 3D printed Albatros D.I set (QD32076).
The model raised details were already sanded away before painting.
Due to the time it took for the set to arrive in the UK from Russia (via Poland), I had already closed up the fuselage.
Therefore I only used the Part 1 sheet which had the external details.
These were brush painted to match the surrounding colours on the model parts.
I did not used the two strips on the upper surface of the lower wing roots as they were way too thick.
Instead I used strips of painted photo-etch.
All surfaces were then airbrushed again with 'Alclad' Light Sheen (ALC311) lacquer.
Weathering was applied using the 'Flory Models' Dark Dirt fine clay wash.
All surfaces were then finally airbrushed with 'Alclad' Light Sheen (ALC311) lacquer to seal it all.
Mike