I've just started a slow and steady build of the Roden Strutter using the Aviattic decals and add-ons. Just working on the interior at present.
My subject aircraft has a CDL fuselage so the I attempted to emulate the roundels showing through on the interior. I sprayed the interiors white, sprayed the roundels (a little heavier than I intended) and then misted some white over the roundel to make it a bit less obvious. I should have gone a little heavier with this.... My circle cutter could not cut a small enough circle for the central red circle, so these are a bit wonky. Anyone know of any good circle cutters?
I painted the framing by hand. Although the supplied masks are very clever, I am better with a paintbrush than scissors and found painting the framing quite easy. I added a bit of pre-weathering as well.
I then applied the interior CDL decals (which are quite subtle over the white), added some rigging from EZ Line and added more weathering. Note I have added a flase floor from plasticard to cover up the join in the fuselage:
Finally here's the lovely resin instrument board which I spent too much time detailing. Although the supplied decals are nice, I used some Airscale ones which I have had in my stash for years.