Messieurs,
Building Roden's Fokker Dr.I (1/32) as prototype V4 I made use of Microscale's Fluid Mask during the finishing process of the upper wing areas ( where the linen shows
a triangular pattern on the front of each wing).
It was not possible to peel of the mask without ruining the paint job; parts of the mask would not come off at all. Water did not help to remove the film.
Finally the wings ended up: build it - bin it.
I'll have to cannibalize a second kit; it is easier to build them anew than to clean off the whole paint job.
kind regards , Gunther