Thanks, Sasho and Lance!
Lance, on the C type turnbuckles, I run a piece of fine wire through one end of the turnbuckle, fold it at the center, pinch the ends together in a hemostat, hold the buckle with my left finger tips and spin the hemostat with my right hand until I have an eyelet. I clip off the end leaving about a 16th of an inch, then glue it into the hole. The turnbuckle will just flop around until you apply tension. I hope that makes sense. If not, I'll try to take pictures.
She's almost finished now. All that remain are the exhaust and the Parabellum. The exhaust will be a challenge since I have to build it from scratch. The Parabellum will be a breeze since I'm using the new Gaspatch offering.



Next pics will be in the completed model section.
Cheers,
Bud