forum.ww1aircraftmodels.com

WW1 Aircraft Modeling => Under Construction => Topic started by: Europapete on July 10, 2018, 04:58:17 AM

Title: No Bull
Post by: Europapete on July 10, 2018, 04:58:17 AM

Hi All,
(https://i.imgur.com/cmEsTLh.jpg) 
OK, if this image works, all hail the mighty Lance! it should show my freshly completed Taurus Models Gnome engine for the DH2. 

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 04:59:09 AM

ALL HAIL LANCE!! YIPPEE!!!!

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 05:00:28 AM

OK, a few more.
(https://i.imgur.com/6Oeqo08.jpg)

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 05:01:28 AM

(https://i.imgur.com/98usvn5.jpg)

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 05:02:00 AM

(https://i.imgur.com/j4p61nv.jpg)

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 05:04:22 AM

These engines that Lukasz does are absolutely amazing. If you haven't tried one yet, just do it. Regards, Pete in RI 

Title: Re: No Bull
Post by: lcarroll on July 10, 2018, 05:30:30 AM

Ha, shows that even a old fart can have the odd good idea, glad it helped Pete! ::) That Gnome is terrific, and I particularly like the way you did the ignition wires; nice work!
Cheers,
Lance

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 06:16:59 AM

Thank you, this motor is a good practice run for the Bentley and Clerget's to come.

Title: Re: No Bull
Post by: lone modeller on July 10, 2018, 06:55:23 AM

That engine is superb. If that is the practice run, what will the later ones look like? I await with great interest.

Stephen.

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 07:02:19 AM

Thank you Stephen, I highly recommend Taurus's engines, the molding is superb. Yes, an Optivisor IS a required tool!

Title: Re: No Bull
Post by: GazzaS on July 10, 2018, 11:01:47 AM

That engine looks amazing.  Love the ignitions wires!

Gaz

Title: Re: No Bull
Post by: Europapete on July 10, 2018, 11:40:33 AM

Thank you Gaz, the wire comes with the engine kit, just twist it around a small drill or needle and cut to size. dead easy. Regards Pete in RI.

Title: Re: No Bull
Post by: RAGIII on July 10, 2018, 10:53:39 PM

Outstanding work on the engine! A thing of beauty for sure!!
RAGIII

Title: Re: No Bull
Post by: NigelR on July 10, 2018, 11:05:43 PM

Outstanding! Love those plug leads.....

Title: Re: No Bull
Post by: gbrivio on July 11, 2018, 02:33:48 AM

Beautiful engine, I like the overall look.
Giuseppe

Title: Re: No Bull
Post by: Europapete on July 11, 2018, 11:04:06 PM

thank you guys, I appreciate the feedback, Regards Pete in RI