forum.ww1aircraftmodels.com
WW1 Aircraft Modeling => Hints and Tips/Questions about modeling => Topic started by: Burbankbill on April 27, 2012, 10:42:57 PM
-
Hello;
I am building the WNWs Sopwith Pup and am wondering the width of the under wing edging is.(where the OD green overlaps the underside of the wing).
Bill
-
Wasn't it an inch?
-
Looks to be around the 1 inch mark.
BVB ;)
-
1.5-2" so quoteth the datafile.
Keith
-
Not a bad guess though :)
-
Therefore somewhere between 1/32 and 1/16 of an inch in 1/32................
-
Therefore somewhere between 1/32 and 1/16 of an inch in 1/32................
I can just see some judge trying to check for this in competition! :o
-
LOL But you know some IMPS judge likely would do just that. :-X Of coarse this is right after he breaks out the FS Color fan to argue your choice of a certain shade of PC 10. But no I'm not bitter. ;)
Highest Regards,
Gregory Jouette
-
...not bitter at all.......little tonic water sir?..... ;)
Steve
-
Steve,
LOL great come back my friend. Actually that "I'm not bitter" was a tongue in cheek comment ,but the other remarks certainly do illustrate how a few IPMS judges behave. How else would they earn those niffty nicknames such as Color Nazi's.
Highest Regards,
Gregory Jouette
-
Not that I enter too much any more but I used to think the same thing. Then one day I figured "Well I came to play the game with your rules so I will just suck it up" If the judge knows what he is actually talking about...........
Steve