forum.ww1aircraftmodels.com

WW1 Aircraft Modeling => WW1 Aircraft Information/Questions => Topic started by: Captain Slower on February 10, 2021, 01:02:28 AM

Title: CSM Nieuport fit question
Post by: Captain Slower on February 10, 2021, 01:02:28 AM
I am stalled a little bit on the RFC Nieuport.  The plywood curved piece that goes underneath the turtle deck seems to want to sit high making the fuselage top not want to fit.  I have sanded all coatings from mating pieces in the cockpit and the frame to it was alligator clipped to the bottom wing piece to avoid that gap.  I realize that the RFC should belts add a brass thick sliver beneath this piece. 

Anyone else having this challenge.  I suspect sanding the bottom down and the possibly the tabs may be in order.
Title: Re: CSM Nieuport fit question
Post by: Alexis on February 10, 2021, 06:50:29 AM
Hey Captain ,

Are you able to post some photo's of this ? It would convay- better to members with possible solutions .


Alexis
Title: Re: CSM Nieuport fit question
Post by: RAGIII on February 10, 2021, 09:01:32 AM
Hey Captain ,

Are you able to post some photo's of this ? It would convay- better to members with possible solutions .


Alexis

I agree Alexis. I started to answer but then wasn't sure I was referring to the right parts/ solution.
RAGIII