Thanks for the comments Dutch and Rick, much appreciated!
Hi all!
I may have been quiet, but the printer has been working overtime as I tried to find the right settings.
Here are the brake drums..
There was a little bit of distortion to the roundness where the supports were, but I think it's acceptable after a bit of sanding down.
Rims look good, but I foresee a lot of drilling....60 spokes on each of the 5 wheels!
I have also completed the jig, adding a support to keep the hub at the right height, and guide markings around the edge which match every 4th spoke to help get the threading right without constant recounting.
The other task now completed, which took a while but has no visible outcome as yet, was to work out the spoke numbering so I can thread them correctly. Only final threading will show whether I have got that correct or not!
That's it for now,
Thanks for looking in!
Ian