Hello, Everyone.
As promised, here are two photos showing the completion of the lower wing section decaling along with most of the PE installed using 5-minute epoxy. I found out that using even a mild setting solution can cause problems. Some Micro-Set very quickly virtually melted one of the decal sections in less time than it takes to say "Dammit!"
Probably a case of over-confidence, as I've been using the Micro-Sol/Set for quite a while, even on my Fokker DVII of a few years ago, with no worries. Fortunately I had a spare section to hand, so all was, and is, well. From now on, warm water is the medium for decals!
I'm having a small problem with a couple of PE bits, but I'll post a short request for assistance later tomorrow. I'm off for a four-hour round trip tomorrow, back (I hope) early evening. Thanks for visiting!