Hi all,
The cockpit assembly is rigged now.
It has the rudder, aileron and elevator control cables.
I've also rigged all of the frame cross bracing wires.
These are made of blacked 0.4 mm diameter tube, 0.08 mm diameter mono-filament and 'Proper Plane' resin turnbuckles.
Only four turnbuckles have not been fitted.
Two below the pilots foot board assembly as they can't be seen.
One on the outside of both cockpit side frames, also that can't be seen and also can interfere with the cockpit fit in the fuselage halves.
The pilots instrument panel also fitted.
I still have the fuel tank and associated pipework to do (not supplied in the kit.
Also weathering of the cockpit and inside the fuselage halves,
Mike