Hi all,
Just a few tweaks to the fuselage and weapons.
The engine cowl was secured to the fuselage with a metal strap around the rear edge of the cowl.
To represent this strap, I used a strip of ‘Bare-Metal’ Matte Aluminium self-adhesive foil.
This was then covered with 'Flory Models' Dark Dirt clay wash, to dirty it up, then sealed with 'Alclad' Light Sheen lacquer (AL-311).
In-flight the main fuel tank was pressurised by a 'Baden' type venturi, which was connected to the tank by an air pipe.
This was represented by drilling into the venturi and fuselage and adding 0.3 mm 'PlusModels' lead wire.
The wire inside the venturi was painted Brass and the rest with 'Tamiya' Rubber Black (XF85).
Both machine guns had elliptical blast deflectors, fitted below the muzzles and these are not represented on the replacement ’GasPatch’ weapons.
The two machine guns were fixed to a mounting under the breach block and also supported at the fuselage by clamping rings around the front of their cooling jackets.
The blast deflectors were cut and shaped from 0.2 mm thick plastic card and CA glued to the weapons.
The rear gun mounts were made from 0.4 mm and 0.2 mm diameter Nickel-Silver tubes. The front mounts were also pinned to the fuselage with 0.3 mm tube.
The front clamping rings were cut from 0.2 mm thick plastic card and CA glued to the cooling jackets.
Mike