And the repetitive question ,asked soooo many times , asked about HV spark plug line...
FWIW here is my take:
Prym: Too big wrong cross section.
Uschi: Too small and looks it. .005"
EZ Line: Mine has a very poor cross section , like mold-shifted.
Copper wire: Right in all aspects , with the right diameter , problems with attachment and forming.
Steel wire: See copper wire.
So at .008" this is what I have chosen:
Ya I know it says .010" but measuring it , it comes in at .008"
I used the same PVA glue as before and glued in the bottom lines and one mag line , for testng purposes :
I will also state that it is my belief the fibre tubes to hold the HV wires are scaled too small in the kit as the numbers in scale wont add up. The Uschi rigging elastic material at .005" is the only stuff that will fit in the tubes but it looks way too small , visually , when its on the engine.
I'll put time on it and see what happens, the atatchment is the problem area.