Thank you everyone for the positive comments , it is great moto to press forward even though I still want to shame the thing with giant green hands !
Today's progress was getting the land gear struts and tail skid in place . I had one hell of a time with the rigging for this and the lower chin and made a bit of a mess and a PE part when flying off into the great blue yawn'der never to be seen again or until i brush my hair ...have found them there before from time to time
Finishing line is closing in with the tail unit and rudder being left and flight controls .
EBF ,
I must admit that I cheated with the double flying wires this time around . I only use one eyelet . At one of the points I pass the line through the eyelet matching both ends . I then slip on two small selves (1mm) on each line . pull this tight and add small drop of super glue right on the eyelet . This locks the line in place . One the other end I pull the line through on the right side of the eyelet and the other on the left . Pull tight and add a drop of super glue to the eyelet . I then slide each selve in place and fix with a drop of glue , trim line once glue has set .
Terri