Hi all,
A few updates.
This kit does not have any locating pins or holes for any of the flight surfaces.
These include the ailerons, fin, tail plane, elevators and the rudder.
These are all intended to be 'butt' glued only, which is never a good idea, especially with resin parts.
Although CA adhesive provides a strong bond, it is prone to 'break away' if subjected to shock loading, such as being knocked.
Therefore I reinforced the mating surfaces by adding either 0.3 or 0.5 mm diameter rods and associated holes.
The exception was the elevators, as the trailing edge of the tail plane is way too thin to drill.
For that I cut photo-etch strips to represent the hinges and to support the elevators to the tail plane.
I've also replaced the resin rear decking strips with sanded down plastic card.
The next job is to created rudder and aileron control cable horns and the associated control cable outlets, none of which are supplied or represented in the kit,
Mike