glad the links will help. i had nothing , not even a datafile to go on. so i trudged thru google and found that stuff which had good views of the slatted floor , framing , seat/tank , control panel, etc etc etc. so i saved them. hopefully this will save you some research time by allowing you to blow up those pics rather than have to find pics. good luck. this may inspire me to get back on mine. i am thinking i will scratch the wings as i just dont care for vac wings. if you just use the top its too thin, if you use both top and bott its so hard and time consuming to get them thin enuff. so i figure a thin balsa core wrapped with very thin styrene sheet. i plan on embossing the ribs from the inside surface using this neat tool i found at the art supply store. its kinda like a pen with 4 changable tips that are 4 diff sized steel balls. i tryed on scrap, take the smallest tip and drag along a ruler and you get a nice embossed rib. good luck on your deadline. but even if you dont make it continue here.