Very clever Prez I wanted to carve a new prop and was struggling to get the correct thickness using plywood - I'll use your method. I'm sure you will have mentioned it somewhere else (and apologies if you did) but how did you finish the propeller?ThanksPaulps I had to keep going back to confirm that this is a 1/72nd scale model!
(Sanded down the ply so I'll get them glued together and see how it turns out. Carved a lot of props for freeflight models in the past, but this is a bit smaller)Paul
Prze, Again, you do not fail to amaze with your builds and skills. I've wanted to carve a prop, but have had trouble sourcing veneer the correct thickness. WD