Hi all,
The underside of the fuselage had a 'V' strut, on which the wing warp controls were located.
Given the lack of detailed information for this aircraft, it's difficult to figure out exactly how these control were configured.
I believe the controls were configured as follows:
Two control cables from the rear bell cranks of the control column torsion bar, were routed vertically through the underside of the fuselage.
These cable were attached to a control lever at the bottom, rear of the V strut.
At the front of the V strut was a 'pulley' and control lever.
Wing warp control cables from both the 'pulley' and lever were attached to the rear spar of both wings.
Flying and landing wires were attached to another V strut towards the front of the fuselage underside.
All wires were routed above the wings to an inverted V strut forward from the cockpit.
The wing warp wires were routed over a pulley on the cockpit strut.
As the control column was moved left or right, the lower rear levers rotated the front pulley and lever.
This caused the trailing edge of the wings to twist either up or down, causing the aircraft to roll in the required direction.
So, based on this I scratch made the underside V strut assembly.
I used the two control levers from the kit.
The struts were 1.4 mm tube with 0.5 mm rod reinforcing.
Control mounting rod is 0.5 mm rod.
The pulley is a spare photo-etch propeller boss plate, secured onto 0.5 mm thick plastic card.
The lightening holes were drilled through using a 0.9 mm diameter drill.
Now it's onto the underside forward V strut,
Mike