Hallo fellows modelers,
after some time I was kept away from the workbench I started over again, although not yet at full steam....
Here are some pics of the completed tail sub assembly:
I thought a lot aboput how to let the wire go through the booms / struts but the piece was so thin I preferred not to pierce it in any way.
So I passed the line "around" the booms, it's not the best but it's not very evident, unless one magnifies the pictures !!!
Then I added that sort of sield to the top edge of the engine housing, the top of the nacelle was not correctly shaped in the kit
I inserted the eyelets in the lower wing (where shown by the arrows)
on the bottom of the inner struts there are at least 4 lines going through so I prepared myself bigger eyelets to let all those wires go through
Last thing I did was the pitot tube:
this is my try, too small to get it better than this...
... painted
That's all for now
Ciao!
Antonio