RIII - Thank you.
And the details are adding up not quickly , but fast enough.
I was going to fab these breathers up , but the offerings from Taurus are spot on. There are also parts to fab an extended breather shown in a number of pics.
You can also see that the water feed pipe to the cylinder jackets has been lined up (P/N E 4 ) .I glued the middle pipe first , then the top pipe w/collar , I then set up a 'pull' and softened the top and middle pipe with some liquid glue and got the bottom pipe to line up. I see a few pics of this pipe NOT lined up , so that's one method on how to do it:
If you do this, make sure you drill the water feed to the carb AFTER you set the pipes, mine is a little off because I drilled prior to insatlling part E 4.
So the pics , here is how I made the extended rear breather pipe:
All on:
Taurus recommends drilling a 1mm hole , I usually do a location hole any way , but no ned to pin.
Thanks for looking.